Hey all,
I've been searching a bunch of posts/forums for the outlet diameter of the borla (or replica) header, but have had no luck. Can anyone clue me in? Is it 2.0, 2.25, or 2.5"
Also, I measured my tailpipe diameter to be 2.0". What is the diameter through the rest of the stock exhaust? . Is it a consistent 2.0" all the way up through the muffler & converter?
Peace!
Borla header & stock exhaust diameter...
Moderator: bajabob
-
- Scoobytruck Master
- Posts: 157
- Joined: Tue Sep 29, 2009 7:07 pm
- Location: Southeast PA (near PA/MD/DE state lines)
Re: Borla header & stock exhaust diameter...
Hello Everyone
I know this is an old post, but does
anyone know the diameter of the
system?
Specifically I'm look for the size of
the upstream joint on the resonator
pipe.
Thanks . . . Brian
I know this is an old post, but does
anyone know the diameter of the
system?
Specifically I'm look for the size of
the upstream joint on the resonator
pipe.
Thanks . . . Brian
2006 Automatic, Non-Turbo Baja, 154,000
Central New York
Short Block 2013
Entire Front Suspension 2015
Rear Backing Plates, Bearings, Brakes 2016
All Coolant Hoses 2016
Factory Tonneau Cover 2016
Rear Struts 2017
Central New York
Short Block 2013
Entire Front Suspension 2015
Rear Backing Plates, Bearings, Brakes 2016
All Coolant Hoses 2016
Factory Tonneau Cover 2016
Rear Struts 2017