scoobytruck.com

Pic of my 2006 Turbo Baja

Does anyone know what type of lock is being used to lock the cover to the tailgate? Looking at the pictures it looks like a dead bolt that you would find at Lowes. I would think they could figure out a better way to lock the cover without have this large chunk of material mounted to the tailgate. Ca...

I am also looking into the Ozzbros cover and had a question about the lock system that they use. From the pictures on the site it is hard to tell exactly how high off the tail gate the bracket sits as well as the type of lock that is being used for the cover. I am worried about the lock freezing in ...

I would like to know if anyone has data to showing that there are benefits running higher priced gas, lets say from Mobil compared to a lower priced gas from Cumberland Farms.

Octaine grades are 93
Price saving is about 5 cents a gal, comparing Mobil to Cumberland Farms.

Thanks
Rick

I would like to replace the stock muffler on my 2006 turbo baja and can't find anything that is a direct replacement.

Looking for suggestions

Thanks
Rick

Do you have any increase in brake dust or brake noise?

The engine knock was being produced by the timing belt tensioner. The noise only happened when the temperture dropped below 60F after the engine was warm the noise would go away.

Problem solved, The aftermarket china made drilled and slotted rotors were junk. They were out of balance right out of the box.

After replacing them with better quality EBC slotted and dimpled rotors the problem went away.

I was planning to install a boost gauge but then started looking into the new plug and play OBD2 gauges. I was going to purchase the dashhawk but was quick to find out the it only works with CAN OBD2 systems, which my 2006 turbo baja is not. It is a straight OBD2 system. That left only the Greddy In...

I just finished installing my new front rotors from EBC. They are nicely machined and powder coated. I purchased the dimpled and slotted rotors from buybrakes.com and would do business with them again. All issues with wheel vibration as speed was eliminated with these rotors from EBC. Awesome finish...

My new rotors arrived today, if you recall I bought some cheap drilled and slotted rotors from brakeplanet and after the install I started to get a front end vibration. Made in China pieces of *%$% Well I recieved my EBC rotors which are dimpled and slotted. 1st impressions. They look awesome, the r...

South of Boston

I have run into an issue with the rotors that I purchased from Brake Planet. After a few hundred miles they have started to cause a front end virbration at highway speed. I have had the wheels balanced and the front end aligment inspected. The mechanic has also inspected the suspension and drive sha...

I am looking into purchasing either the MSD ignition dashhawk or the Greddy Informeter. http://www.dashhawk.com/ http://www.greddy.com/products/display/?Category=electronics&SubCategory=56 Has anyone used these and what are your first impressions. Also let me know if you have used these in a Tur...

My 2006 baja turbo just started to suffer from a vibration that you can feel on the floor boards and the seat of your pants. Steering vibration is minimal. While driving only at 65 to 75 MPH I get a vibration, any speed lower then 65 or higher than 75 the vibration is gone. I am thinking it may be r...