Trailer wiring harness

Technical Discussions - Got a mechanical problem?

Moderator: bajabob

Post Reply
tiogaco
Scoobytruck Lurker
Posts: 2
Joined: Thu May 16, 2019 10:08 am

Trailer wiring harness

Post by tiogaco » Fri May 17, 2019 4:00 am

The trailer wiring harness on my baja is all corroded and busted. This is on the car side, not on the trailer side.

I can see a connector that splits and gives me the end to hook up trailer lights and the other then which goes into the body and I think up into the rear taillight. It looks like I can pop off the rear external plastic trim and the rear taillight to access this.

Does this sound right? Part number for the replacement?

ZUBAJA
Scoobytruck Master
Posts: 111
Joined: Sun Apr 15, 2018 4:38 pm

Re: Trailer wiring harness

Post by ZUBAJA » Fri May 17, 2019 4:57 am

There is an access plug under the right rear for a "plug and play" trailer light system. It is capped from the factory. You remove the cap, plug in the harness (w/ module), secure the wires, and you are good to go. Dennis

tiogaco
Scoobytruck Lurker
Posts: 2
Joined: Thu May 16, 2019 10:08 am

Re: Trailer wiring harness

Post by tiogaco » Wed May 22, 2019 7:14 am

Yup, that's the part that is messed up.

If you look up under there, you can see where that cable Ys goes up into I think the rear passenger tail lights.

Post Reply