EZ30 Swap into a 2003 NA Baja

Technical Discussions - Got a mechanical problem?

Moderator: bajabob

Post Reply
spitsomeearth
Scoobytruck Lurker
Posts: 1
Joined: Sat May 05, 2018 11:01 pm

EZ30 Swap into a 2003 NA Baja

Post by spitsomeearth »

Greetings!

So I recently picked a 2001 outback 3.0 (non-VDC) for dirt cheap. It's headgaskets are bad but other than that it is running very good. I did some reading on what it takes to swap the EZ30 and it seems fairly simple and I think I can handle the mechanical work. I'm not as electrically inclined as I'd like to be, so with that being said, I was wondering if I could get some help from others that have done it.

-What do I do with the parts of the new harness that don't have anything to go to? I don't plan on swapping the seats, heated windshield/mirror components, etc.

-How should I wire up the rear cargo/tail light over the bed?

-What are some components that I need to swap over to make the harness work?

Thanks!
User avatar
kamesama980
Scoobytruck Master
Posts: 369
Joined: Mon Feb 29, 2016 6:54 am

Re: EZ30 Swap into a 2003 NA Baja

Post by kamesama980 »

the engine and body harness are separate. you need to get the PCM and engine harness along with the engine and adapt a few pins/wires to your body harness.
-Russell
"You don't get to judge me for how I fix what you break"
03 sport 5mt
05 turbo 5mt vf39 and other STI bits, 3" turbo-back
Post Reply